Return to the BUILD

“In this stage you’ll finish the first seat by fitting the cover in place.




Materials: The Seat Cover is pliable PVC rubber.


Fitting the Seat Cover

Steps  1-2

Retrieve your Seat assembly from the previous stage. Slide it, Seat Backrest first, into the Seat Cover, as shown:

Make sure the tab at the ‘neck’ of the Backrest fit into this notch of the Cover:

And, ensure all three edges at the bottom of the Cover wrap around the Seat base, as shown:


The cushion surfaces of the Seat are flexible and respond just like a real seat. You know you want this interior design in your own car!

Next Up

 Stage 010 – Carburetor Body (Rear), Inlet Manifold, Carburetor Detail, Velocity Stacks

Leave a Reply

Your email address will not be published. Required fields are marked *