STAGE 016

 Return to the BUILD


“You’ll now fit the starter motor to the bell housing cover, then fix it onto the bell housing assembly.

 

Contents


Parts

Materials: The Bell Housing Cover is metal and the other parts are plastic.

Build


Fitting the Starter Motor and Bell Housing Cover

Steps 1-2

Press the D-shaped pin of the Starter Motor Detail into this matching hole of the Starter Motor, as shown:

Steps 3-4

Fit the keyed post of the Starter Motor into the matching hole at this location of the Bell Housing Cover, as shown:

Step 5

Secure the Starter Motor into place from the other side with one (1) PS02 screw:

Step 6

Retrieve your Gearbox from the previous stage. Fit this Bell Housing Cover into the matching opening of the Bell Housing, as shown:

Step 7

Secure the Cover to the Bell Housing with three (3) DS01 screws.

This your friendly reminder to try using 3-in-One Oil on all screws going into metal:

Thoughts


Keep this Gearbox assembly safely stored until the next parts arrive. We will continue to build up, and then mount, the engine throughout the entire next pack – I can’t wait!

Next Up


 Stage 017 – Engine Block, Bracket, Breather Pipe (Coming Soon)

Leave a Reply

Your email address will not be published. Required fields are marked *